|
|
INSTRUCTIONS
for installing the SureStep® antislip rubber profile
for stairs.
|
| Page: |
Figure 2
|
Tiling may begin three hours after the adhesive applied to the profile has hardened.
Use floor tiles with a rough surface. Ceramic granite is preferred for outdoor stairs.
Use a thick-layer, cement-based polymerized adhesive***
First, install vertical tiles (5) covering stair risers. The top edge of the vertical tile (5) should, without any gap, firmly prop up the profile from below. To prevent a vertical tile (5) from sliding downward while the adhesive (8) sets, it is supported from below by wedges (6) consisting of tile fragments.
Next, the tiles covering horizontal treads (7) are laid. The front edge of the horizontal tile (7) is fit snugly against the profile leaving no gap.
|
|
|
|
| Page: |
|
